Pac Automobile Accessories User Manual download pdf

06-14-07

SWI-JACK

Universal Steering Wheel Control Interface

Before You Start

A. Is this product compatible with the vehicle?

• See application guide (separate sheet) for listing of vehicles and connection information. If not, please visit

http://www.pac-audio.com/swixprogramming/swixprogramming.asp for the most current list of compatible

vehicles.

B. Prepare for the installation.

• If possible, install the SWI-JACK while you are installing the new head unit. Keep in mind you may need to plug in

the factory stereo to locate certain wires; therefore do not complete the head unit installation until the SWI-JACK is

working properly.

• Plan a general installation location for both the SWI-JACK plug and the control body. Keep in mind that the sup-

plied wire harness is two feet long, and the 1/8" plug harness is three feet long.

• Use a multimeter or approved measuring device for checking vehicle circuits.

Pacific Accessory Corporation

SEEK

PRESET

AM FM

VOLUME

PLAY

MUTE

Power

Jack for the SWI-JACK

Steering wheel

audio control wire

To Kenwood wired

remote control input

Installation Instructions

For Alpine, JVC, Clarion and

Kenwood OEM Steering Remote

Ready Radios

For Alpine, Clarion or JVC radios, connect the SWI-JACK 1/8" plug into the radio's Steering Wheel input jack on

back of radio or wire harness. For Kenwood radios, connect the blue/yel wire to the Remote Input wire (blue/yel) of radio.

Blaupunkt radios with optional wireless remote inputs are supported by the SWI-JACK, however we do not

supply any connectors or support for Blaupunkt. It is up to the consumer or installer to supply this connector. Use

vehicle Connector Chart and use VW connector as reference. Connect the SWI-JACK's blue/yel wire to pin #11 of VW

connector. The connector you obtain may come with two of three pieces, however the connector (usually green) should

show pin #11 on it.

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Installation Instructions

106-14-07SWI-JACK Universal Steering Wheel Control InterfaceBefore You StartA. Is this product compatible with the vehicle?• See application guide (s

Page 2 - SWI-JACK

2SWI-JACKWiring ConnectionsStep 1.Connect the BLACK wire to ground (-).Verication: Wire or location registers a constant (-) when probed.Step 2.Conne

Page 3

306-14-07Step 5.Refer to The Vehicle Application Guide. Note the INTERFACE Version Number next to the selected vehicle. Fill in the information below

Page 4

4Step 18.Press and hold program-ming/mode button on SWI-JACK. LED will light.Step 19.Release programming/mode button. SWI-JACKSWI-JACKSWI-JACKYou only

Page 5 - 06-14-07

506-14-07Programming the SWI-JACK to Control the Head Unit (cont.)The SWI-JACK must be programmed in the specic order shown in the chart below. If a

Page 6

6SWI-JACKSWI-JACKStep 22.Release the button.The LED will turn on back on. Skip to Step 24.Step 24.If you need to program more buttons, repeat step 20

Page 7 - Testing the SWI-JACK

706-14-07Testing the SWI-JACK(For Version #4 only) Test each Heater function of the steering wheel controls. The TEMP and FAN should work properly. Wh

Page 8 - Troubleshooting Guide

8Troubleshooting GuideWorking on a new or unlisted vehicle?We are always looking for new vehicle information. If you’ve successfully completed the in

Comments to this Manuals

No comments

Pac Automobile Accessories User Manual

Browse online or download User Manual for For the car Pac Automobile Accessories. PAC Automobile Accessories User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Pac Automobile Accessories